web analytics

PassLeader 100% Pass Guaranteed IT Exam Dumps Free Download

Free Collection of VCE and PDF Braindump with New Exam Questions

The Professional Cisco 350-001 Exam Free Dumps Help You 100% Pass Exam (91-100)

QUESTION 91
Refer to the exhibit. Which of the following options will trigger the applet?
911
A.    an external Cisco IOS event
B.    a manually run policy event
C.    a preconfigured timer
D.    an automated RPC call

Answer: B

QUESTION 92
Refer to the exhibit. Which output will the EEM applet in the exhibit produce?
921

A.    The output of show version will be executed every 5 hours.
B.    The output of show log will be executed every 5 hours.
C.    The output of show log will be executed every 5 days.
D.    The output of show log will be executed every 5 minutes.

Answer: C

QUESTION 93
Which NetFlow version should be used to collect accounting data for IPv6 traffic?

A.    version 1
B.    version 5
C.    version 7
D.    version 8
E.    version 9

Answer: E

QUESTION 94
To troubleshoot network issues more accurately, milliseconds should be included in the syslog of the router. Which command will achieve this?

A.    service timestamps log datetimec msec
B.    logging timestamps msec
C.    syslog timestamps hour minute second miliseconds
D.    service logging timestamp msec
E.    logging service timestamp msec

Answer: A

QUESTION 95
Refer to the exhibit. Based on the above commands, when will the output of the show log command be saved?
951
A.    Each time the total CPU utilization goes below 50 percent
B.    Each time the total CPU utilization goes above 80 percent
C.    Every 5 minutes while the total CPU utilization is above 80 percent
D.    Every 5 seconds while the total CPU utilization is above 80 percent
E.    Every 5 minutes while the total CPU utilization is below 50 percent
F.    Every 5 seconds while the total CPU utilization is below 50 percent

QUESTION 96
What is the purpose of an explicit “deny any” statement at the end of an ACL?

A.    none, since it is implicit
B.    to enable Cisco IOS IPS to work properly; however, it is the deny all traffic entry that is actually required
C.    to enable Cisco IOS Firewall to work properly; however, it is the deny all traffic entry that is actually required
D.    to allow the log option to be used to log any matches
E.    to prevent sync flood attacks
F.    to prevent half-opened TCP connections

Answer: D

QUESTION 97
Which of these is mandatory when configuring Cisco IOS Firewall?

A.    Cisco IOS IPS enabled on the untrusted interface
B.    NBAR enabled to perform protocol discovery and deep packet inspection
C.    a route map to define the trusted outgoing traffic
D.    a route map to define the application inspection rules
E.    an inbound extended ACL applied to the untrusted interface

Answer: E

QUESTION 98
Which statement correctly describes the disabling of IP TTL propagation in an MPLS network?

A.    The TTL field from the IP packet is copied into the TTL field of the MPLS label header at the ingress edge LSR.
B.    TTL propagation cannot be disabled in an MPLS domain.
C.    TTL propagation is only disabled on the ingress edge LSR.
D.    The TTL field of the MPLS label header is set to 255.
E.    The TTL field of the IP packet is set to 0.

Answer: D

QUESTION 99
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correct BGP session endpoint addresses and the correct BGP session hop-count limit (EBGP multihop). What is a good first test to see if BGP will work across the firewall?

A.    Attempt to TELNET from the router connected to the inside of the firewall to the router connected to the outside of the firewall. If telnet works, BGP will work, since telnet and BGP both use TCP to transport data.
B.    Ping from the router connected to the inside interface of the firewall to the router connected to the outside interface of the firewall. If you can ping between them, BGP should work, since BGP uses IP to transport packets.
C.    There is no way to make BGP work across a firewall without special configuration, so there is no simple test that will show you if BGP will work or not, other than trying to start the peering session.
D.    There is no way to make BGP work across a firewall.

Answer: C

QUESTION 100
Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of these?

A.    one global STP instance for all VLANs
B.    one STP instance for each VLAN
C.    one STP instance per set of VLANs
D.    one STP instance per set of bridges

Answer: C

The Professional Cisco 350-001 Exam Free Dumps Help You 100% Pass Exam

         

Latest and 100% Pass Guaranteed IT Exam Dumps Download © 2015 Frontier Theme