What does Cisco recommend when you are enabling Cisco IOS IPS?
A. Do not enable all the signatures at the same time.
B. Do not enable the ICMP signature.
C. Disable the Zone-Based Policy Firewall because it is not compatible with Cisco IOS IPS.
D. Disable CEF because it is not compatible with Cisco IOS IPS.
Refer to the exhibit. Which statement is correct?
A. OSPF peers are using Type 1 authentication
B. OSPF peers are using Type 2 authentication
C. Authentication is used, but there is a password mismatch
D. The OSPF peer IP address is 172.16.10.36
Which two statements are true about Unicast Reverse Path Forwarding Loose Mode? (Choose two.)
A. It is used in multihome network scenarios.
B. It can be used with BGP to mitigate DoS and DDoS.
C. It does not need to have CEF enabled.
D. It is enabled via the interface level command ip verify unicast reverse-path.
E. It cannot be used with “classification” access lists.
Refer to the exhibit. What would be the security risk when you are using the above configuration?
A. The locally configured users would override the TACACS+ security policy.
B. It would be impossible to log in to the router if the TACACS+ server is down.
C. The default login policy would override the TACACS+ configuration.
D. If the TACACS+ server failed, no authentication would be required.
Which three protocols should be explicitly managed by using a CoPP policy on an Internet border router? (Choose three.)
What is true about IP Source Guard with port security?
A. Binding should be manually configured.
B. It is not supported if IEEE 802.1x port-based authentication is enabled
C. The DHCP server must support option 82, or the client is not assigned an IP address.
D. It filters based on source IP address only.
Refer to the exhibit. Which option best describes how the virtual MAC address is composed?
A. based on a randomly generated number
B. based on the burned-in MAC address of the router
C. based on a number manually configured by the administrator
D. based on the configured standby group number
Which two commands are required to enable multicast on a router, knowing that the receivers only supports IGMPv2?(Choose Two)
A. IP PIM RP-address
B. IP PIM ssm
C. IP PIM Sparse-mode
D. IP PIM Passive
A branch router is configured with an egress QoS policy that was designed for a total number of 10 concurrent VOIP Calls. Due to Expansion, 15 VOIP Calls are now running over the link, but after the 14th call was established, all calls were affected and the voice quality was dramatically degraded. Assuming that there is enough bandwidth on the link for all of this traffic, which part of the QOS configuration should be updated due to the new traffic profile?
A. Increase the shaping rate for the priority queue.
B. Remove the policer applied on the priority queue.
C. Remove the shaper applied on the preiority queue.
D. Increase the policing rate for the priority queue.
A new Backup Connection is being deployed on a remote site router. the stability of the connection has been a concern. in order to provide more information to EIGRP Regarding this interface, You wish to incorporate the “Reliability” cost metric in the EIGRP Calculation with the command metric weights 1 0 1 0 1.
What impact will this modification on the remote site router have for other existing EIGRP neighborships from the same EIGRP Domain?
A. Existing Neighbors will immediately begin using the new metric.
B. Existing Neighbors will use the new metric after clearing the EIGRP Neighbors.
C. Existing Neighbors will resync, maintaining the neighbor relationship
D. All ecisting neighbor relationships will go down
The Professional Cisco 350-001 Exam Free Dumps Help You 100% Pass Exam