QUESTION 301There is some confusion on this sim and what it is. So I will tell you that it is a window with 4 squares on the left side. Click each one to see the question. Again, there are 4 questions and one topology. Click the `topology’ button at the bottom of the sim to […]
350-001 sample questions
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (291-300)
QUESTION 291Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router? A. Take any packet sourced from any address in the 10.2.0.0/16 network or destined to 10.1.14.25 and set the next hop to 10.1.1.1B. Take any packet sourced from any address in the […]
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (281-290)
QUESTION 281Refer to the exhibit. For this network, assume all routers have been configured to run EIGRP in AS 100, and have also been configured to run EIGRP on all connected links. If the link between R3 and R4 fails, how many queries will R5 and R6 receive? A. R6 will receive two queries, one […]
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (271-280)
QUESTION 271Study the exhibit carefully. Two directly connected routers are configured with OSPF. The output presented in the exhibit can be seen on the console of one router. What most likely cause this problem? A. The maximum transmission unit on either side of the link is not the sameB. This debug is wrong, OSPF does […]
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (231-240)
QUESTION 231You deployed new fibers in your network to replace copper spans that were too long. While reconnecting the network, you experienced network problems because you reconnected wrong fibers to wrong ports. What could you do to prevent this type of problem in the future, particularly when connecting and reconnecting fiber pairs? A. Only use […]
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (221-230)
QUESTION 221What is the default maximum reservable bandwidth (percentage) by any single flow on an interface after enabling RSVP? A. 75 percentB. 60 percentC. 56 percentD. 50 percentE. 25 percent
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (211-220)
QUESTION 211When troubleshooting a network, the output of the command show interfaces indicates a large number of runts. What is a runt? A. the number of packets that are discarded because they exceed the maximum packet size of the mediumB. errors created when the CRC generated by the originating LAN station or far-end device does […]
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (171-180)
QUESTION 171Which two of these steps are minimum requirements to configure OSPFv3 under IPv6? (Choose two.) A. Configure a routing process using the command ipv6 router ospf [process-id].B. Add the network statement for the interfaces on which OSPF will run.C. Configure OSPF on the interface that it will run on.D. Use the passive-interface command on […]
The Professional Cisco 350-001 Exam Free Dumps Help You 100% Pass Exam (131-140)
QUESTION 131Which of these best identifies the types of prefixes a router running BGP will advertise to an EBGP peer? A. prefixes received from any other BGP peer and prefixes locally originated via network statements or redistributed to BGPB. all prefixes in its IP routing tableC. only prefixes received from EBGP peers and prefixes locally […]
The Professional Cisco 350-001 Exam Free Dumps Help You 100% Pass Exam (111-120)
QUESTION 111Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2. What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails, without using any type of EtherChannel link-bundling? A. Increase the root bridge priority (increasing the numerical priority number) […]
The Professional Cisco 350-001 Exam Free Dumps Help You 100% Pass Exam (51-60)
QUESTION 51What is the flooding scope of an OSPFv3 LSA, if the value of the S2 bit is set to 1 and the S1 bit is set to 0? A. link localB. area wideC. AS wideD. reserved
The Professional Cisco 350-001 Exam Free Dumps Help You 100% Pass Exam (1-10)
QUESTION 1In order to maintain security, with which hop count are IPv6 neighbor discovery packets sent? A. 0B. 1C. 255D. 256