web analytics

PassLeader 100% Pass Guaranteed IT Exam Dumps Free Download

Free Collection of VCE and PDF Braindump with New Exam Questions

Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (291-300)

QUESTION 291
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?
2911

A.    Take any packet sourced from any address in the 10.2.0.0/16 network or destined to 10.1.14.25 and set the next hop to 10.1.1.1
B.    Take any packet sourced from any address in the 10.2.0.0/16 network and destined to 10.1.14.25 and set the next hop to 10.1.1.1
C.    Nothing; extended access lists are not allowed in route maps used for policy-based routing
D.    Drop any packet sourced from 10.2.0.0/16

Answer: A

QUESTION 292
You work as a network technician at Company.com, study the exhibit provided. You are implementing this QoS configuration to improve the bandwidth guarantees for traffic towards two servers, one with the IP address 5.5.5.5 and the other with the IP address 5.5.5.4. Even after the configuration is applied, performance does not seemto improve. Which will be the most likely cause of this problem?
2921

A.    The policy map mark has been applied on a half-duplex Ethernet interface; this is not supported.
B.    The policy map queue is configured on the wrong interface; it is applied on the serial interface whereas traffic is going over the tunnel interface.
C.    The class maps are wrongly configured
D.    The ip nbar protocol-discover command cannot be configured together with a service policy output on the serial interface.
E.    This is probably a software bug

Answer: C

QUESTION 293
On the basis of the exhibit provided, assuming that EIGRP is the routing protocol, then at R5, what would be the status of each path to 172.30.1.0/24?
2931

A.    the path through R3 would be the successor, the path through R1 would be a feasible successor, and the path through R4 would be neither a successor nor a feasible successor
B.    the path through R3 would be the successor, and the paths through R1 and R4 would be feasible successors
C.    the path through R1 would be the successor, the path through R3 would be a feasible successor, and the path through R4 would be neither a successor nor feasible successor
D.    not enough information has been given to figure out what the status of each route would be

Answer: A

QUESTION 294
Refer to the exhibit. We have IPv6 multicast configured between R5 and R6, which three statements are true based on the partial command output shown? (Choose three)
2941

A.    R6 has joined one multicast group, and it expires in 46 seconds.
B.    The rendezvous point address is 2001:DB8:5::5.
C.    The multicast group address is FE80::216.
D.    R6 has joined two multicast groups, and it expires in 7 seconds.
E.    The multicast entry is operating in sparse mode.
F.    The multicast groups are FF04::10 and FF04::30.

Answer: BEF

QUESTION 295
Refer to the exhibit. We have IPv6 multicast configured between R5 and R6. Which two
statements are true based on the partial command output shown? (Choose two)
2951
 

A.    R6 has joined the multicast group, and it expires in 46 seconds
B.    The rendezvous point address is FE80::216:47FF:FEBB:FF0
C.    The multicast group address is FF04::10
D.    The multicast entry is operating in dense mode
E.    The multicast route has been pruned

Answer: CE

QUESTION 296
Refer to the exhibit. You have just configured R5 and R6 to run EIGRPv6 as shown; the IPv6 ping from R5 to R6-loopback 0 is failing. Which statement could be the reason?
2961
2962

A.    The loopback interfaces on R5 and R6 must be configured on an EIGRPv6 As number other than 56.
B.    The loopback interfaces on R5 and R6 must be configured to EIGRPv6 As number 56.
C.    You need to configure the EIGRPv6 router process on both routers.
D.    You need to configure the EIGRPv6 router process in at least one of the routers.
E.    You should remove the ipv6 eigrp 56 from the loopback interfaces on both routers.

Answer: C

QUESTION 297
Refer to the exhibit. What effect will the as-path filter command that is configured on R4 create BGP routing table?
2971
2972

A.    It will have all three routes on the R4 BGP routing table.
B.    It will have none of the three routes on the R4 BGP routing table.
C.    It will have only the route 30.30.1.0/24.
D.    It will have routes 40.40.1.0/24 and 200.200.6.6/32.
E.    It will have routes 30.30.1.0/24 and 200.200.6.6/32.
F.    It will have routes 30.30.1.0/24 and 40.40.1.0/24.

Answer: B

QUESTION 298
There is some confusion on this sim and what it is. So I will tell you that it is a window with 4 squares on the left side. Click each one to see the question. Again, there are 4 questions and one topology. Click the `topology’ button at the bottom of the sim to see it. There is only one topology for all 4 questions. You do NOT log into any routers. All configuration is provided as text in the question. NOTE: The actual topology may vary with the routing protocol questions selected for the sim and the number of routers could be as high as R6
2981
Given R1#show ipv6 mroute
(*, FF02::2), 00:02:57/never, RP 2002:2222::2, flags: SPC
Incoming interface: FastEthernet0/0
RPF nbr: FE80::266:66FF:FE66:6666
(*, FF04::6), 00:02:57/never, RP 2002:2222::2, flags: SPC
Incoming interface: FastEthernet0/0
RPF nbr: FE80::266:66FF:FE66:6666

A.    Some thing about expiry for Multicast group 1 after 60 second
B.    The Multicast group address is 2002:2222::2
C.    Some thing about expiry for Multicast group 1 after x second
D.    The RP address is 2002:2222::2
E.    The Multicast Group addresses are FF02::2 and FF04::6
F.    The Multicast Group addresses are (FF08:: some strange number i think it was the RPF NBR)
G.    The operating Mode is sparse mode

Answer: DEG

QUESTION 299
There is some confusion on this sim and what it is. So I will tell you that it is a window with 4 squares on the left side. Click each one to see the question. Again, there are 4 questions and one topology. Click the `topology’ button at the bottom of the sim to see it. There is only one topology for all 4 questions. You do NOT log into any routers. All configuration is provided as text in the question.
NOTE: The actual topology may vary with the routing protocol questions selected for the sim and
the number of routers could be as high as R6
2991
which type of the LSA will be added in the OSPF broadcast network type?

A.    LSA1
B.    LSA2
C.    LSA3
D.    LSA5
E.    LSA7

Answer: B

QUESTION 300
There is some confusion on this sim and what it is. So I will tell you that it is a window with 4 squares on the left side. Click each one to see the question. Again, there are 4 questions and one topology. Click the `topology’ button at the bottom of the sim to see it. There is only one topology for all 4 questions. You do NOT log into any routers. All configuration is provided as text in the question.
NOTE: The actual topology may vary with the routing protocol questions selected for the sim and
the number of routers could be as high as R6
3001
which one is the Designated Router router ID? An example of show ip ospf database will be given

A.    7.7.1.1
B.    7.7.5.5
C.    7.7.6.6
D.    22.22.2.2
E.    7.7.2.2

Answer: E

Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back

         

Latest and 100% Pass Guaranteed IT Exam Dumps Download © 2015 Frontier Theme