web analytics

PassLeader 100% Pass Guaranteed IT Exam Dumps Free Download

Free Collection of VCE and PDF Braindump with New Exam Questions

Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back (251-260)

Which IOS security feature is configured by the ip inspect inspection-name {in | out} command?

A.    IPsec site-to-site VPN
B.    Cisco AutoSecure
C.    Cisco IOS Firewall
D.    IPS

Answer: C

If a Cisco switch is configured with VTPv1 in transparent mode, what is done with received VTP advertisements?

A.    They are discarded
B.    The contents are altered to reflect the switch’s own VTP database and then they are forward out all trunking ports
C.    The changes within the advertisements are made to the switch’s VTP database.
D.    The contents are ignored and they are forwarded out all trunking ports.

Answer: D

Refer to the following descriptions, which three are true about Cisco spanning-tree features? (Choose three.)

A.    RPVST+ converges faster than RSTP during a topology change.
B.    STP BPDUs are relayed by all non-root bridges and RSTP BPDUs are generated by each bridge.
C.    RSTP can only achieve rapid transition to Forwarding on edge ports and on point-to-point links.
D.    RPVST+ and RSTP are both based upon the IEEE 802.1w specification.

Answer: BCD

Which switch port error is an indication of duplex mismatches on 10/100/1000 IEEE 802.3u Gigabit Ethernet ports?

A.    FCS errors
B.    Runts
C.    Multiple collisions
D.    Alignment errors

Answer: C

Which one of the following potential issues is eliminated by using split horizon?

A.    Joined horizons
B.    Packet forwarding loops
C.    cisco Express Forwarding load-balancing inconsistency
D.    Asymmetric routing throughout the network

Answer: B

Phase I and Phase II DMVPN differ in terms of which of these characteristics?

A.    Utilization of spoke-to-spoke dynamic tunnels
B.    Utilization of multipoint GRE tunnels at the hub site
C.    Utilization of hub-to-spoke dynamic tunnels
D.    Support for multicast

Answer: A

Policy-based routing allows network administrators to implement routing policies to allow or deny paths based on all of these factors except which one?

A.    End system
B.    Protocol
C.    Application
D.    Throughput

Answer: D

Two routers are connected by a serial link, and are configured to run EIGRP on all interfaces. You examine the EIGRP neighbor table on both routers (using the show ip eigrp neighbor command) and see that the router connected over the serial link is listed as a neighbor for a certain amount of time, but is periodically removed from the neighbor table. None of the routes from the neighbor ever seem to be learned, and the neighbor transmission statistics (SRTT, RTO, and Q Count) seem to indicate that no packets are being transmitted between the neighbors. Which would most likely cause this problem?

A.    While multicast packets are being successfully sent over the link, unicast packets are not
B.    There is a bug in the EIGRP code that needs to be fixed.
C.    This is correct behavior for the first few minutes of EIGRP neighbor formation. After four or five cycles, it should straighten itself out and the neighbor
D.    The hello or hold intervals are set differently on the two routers.

Answer: A

Which two steps below should you perform on the hub router while configuring EIGRP routing over DMVPN (mGRE tunnel)? (Choose two.)

A.    Set the NHRP hold time to match the EIGRP hold time
B.    Add the enable eigrp stub command
C.    Add the disable eigrp as-member split-horizon command
D.    Add the disable eigrp as-member next-hop-self command

Answer: CD

Area Border Router (ABR) is a router located on the border of one or more OSPF areas that connect those areas to the backbone network. An ABR will inject a default route into which two types of areas? (Choose two.)

A.    Area 0
B.    NSSA
C.    Totally stubby
D.    Stub

Answer: CD

Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back


Latest and 100% Pass Guaranteed IT Exam Dumps Download © 2015 Frontier Theme