Refer to the exhibit. R7 (in Area 1) is redistributing routes that it learned from EIGRP into the OSPF process. R12 (in Area 4) receives a packet destined for a network in the EIGRP domain. What routing table entry will R12 have that will enable it to forward the packet?
A. the specific network entry redistributed by R7 and propagated through the OSPF domain
B. a summary route generated by R7 and propagated through the OSPF domain
C. a default route generated by R7 and propagated through the OSPF domain
D. a summary route generated by R4 and propagated to R12
E. a default route generated by R4 and propagated to R12
Having multiple unknown unicast frames in a switch would most likely deplete which of these resources?
A. available MAC addresses in the system
B. available memory for frame buffering
C. available bandwidth
D. electrical power
E. TCAM entries
A. ACL 101 needs to have at least one permit statement in it or it will not work properly.
B. The ip inspect test out command needs to be used instead of the ip inspect test in command to make the configuration work.
C. Ethernet 0 is the trusted interface and Ethernet 1 is the untrusted interface.
D. Ethernet 0 needs an inbound access list to make the configuration work.
E. Ethernet 0 needs an outbound access list to make the configuration work.
Refer to the exhibit. This network is using a classful routing protocol. Subnet 10.1.1.0/24 is sourced by Router A and advertised to Router B. Router B then sends updates to Router C, which forwards updates to Router D, which propagates routing information beyond. With regards to only the 10.1.1.0/24 subnet, what does Router D advertise out its 10.1.4.0/24 interface?
E. No update is sent regarding the 10.1.1.0/24 subnet
Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards, the exhibit shows your configuration in a local switch1. However, EtherChannel is not coming up.
Which one of these statements could be a possible reason?
A. EtherChannel is only available in Cisco equipment.
B. The customer side is supposed to be running PAgP, which is a Cisco standard.
C. PAgP is not an IEEE standard. VRRP should be used.
D. The configuration on switch1 needs to be modified to use LACP.
Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?
A. Ethernet interfaces were configured as point-to-point.
B. Process IDs are not matching.
C. Configured bandwidths do not match on both interfaces.
D. Broadcasts and multicast are not being propagated over the Ethernet services.
E. OSPF cost does not match on both interfaces.
Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider?
A. OSPF standard hellos
B. Cisco Discovery Protocol link detection
C. Bidirectional Forwarding Detection
D. Fast Link Pulse
While troubleshooting a network, you need to verify the liveness of hosts in the subnet 192.168.1.64/26. All of the hosts are able to reply to ping requests. How would you confirm the existing nodes using one single command?
A. ping 192.168.1.255
B. ping with sweep option
C. ping 192.168.1.127
D. ping 192.168.1.64
E. ping with broadcast option
Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B. What would be two suggestions to load-balance the traffic across both WAN links? (Choose two.)
A. Make HSRP track interfaces between the edge and core routers.
B. Replace HSRP with GLBP.
C. Add crossed intrasite links: R1-R4, R2-R3, R5-R8, and R6-R7.
D. Make R3 and R8 have lower HSRP priority than R1 and R7.
E. Replace HSRP with VRRP.
Refer to the exhibit. According to the output of the command show tag-switching forwarding-table, which four of these statements are true? (Choose four.)
A. Packets to the IP address 10.10.10.5/32 will be tagged with “17” toward the next hop.
B. Label “19” will be advertised to MPLS neighbors so that they can use this label to reach the IP address 10.10.10.6/32.
C. IP address 10.10.10.4/32 is directly connected to the neighbor router on serial 3/0.
D. Packets arriving with label “17” will be forwarded without any label toward serial 4/0.
E. Packets arriving with label “20” will be forwarded with label “21” after label-swapping.
F. Label “20” is advertised to MPLS neighbors so that they can use this information to reach the prefix 10.10.10.8/32.
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back