What s the default stratum clock on a Cisco router, when you see the key word “master”
configured on the NTP line?
Though many options are supported in EIGRPv6, select two options from the below list that are supported. Choose 2
C. per-interface configuration
D. prefix-list support via route-map
E. prefix-list support via distribute-list
During the IPv6 address resolution, a node sends a neighbor solicitation message in order to discover which of these?
A. The Layer 2 multicast address of the destination node
B. The solicited node multicast address of the destination node
C. The Layer 2 address of the destination node based on the destination IPv6 address
D. The IPv6 address of the destination node based on the destination Layer 2 address
Which one of these statements is true of OSPF type 5 LSAs?
A. They are used to summarize area routes to other areas.
B. They are used in not-so-stubby areas to propagate external routes.
C. They are used to notify areas of the ASBR.
D. They are flooded to all areas except stub areas (external route).
Which OSPF LSA type does an ASBR use to originate a default route into an area?
A. LSA 1
B. LSA 3
C. LSA 4
D. LSA 5
E. LSA 7
A. The network statements are misconfigured.
B. The IP address statements are misconfigured.
C. The autonomous system is misconfigured.
D. There is a physical issue with the cable.
A. The routers are not on the same network.
B. The network statements do not match.
C. The process number does not match.
D. The MTU does not match.
E. The OSPF cost does not match.
F. There is a physical issue with the cable.
A. Router ISP1 should be configured to peer with router B.
B. Router ISP2 should be configured with no synchronization.
C. Router ISP1 should be configured with no synchronization.
D. Router ISP2 should be configured with no auto-summary.
E. Router ISP1 or IPS2 should be configured with network 220.127.116.11 mask 255.255.255.0.
Two BGP peers connected through a routed firewall are unable to establish a peering relationship. What could be the most likely cause?
A. BGP peers must be Layer 2-adjacent.
B. EBGP multihop is not configured.
C. The firewall is not configured to allow IP protocol 89.
D. The firewall is not configured to allow UDP 179.
Passleader 350-001 Braindumps Help You Pass Exam With 100% Money Back