Refer to the exhibit. Why is AS 65333 in parentheses?
A. It is an external AS.
B. It is a confederation AS.
C. It is the AS of a route reflector.
D. It is our own AS.
E. A route map has been applied to this route.
F. The BGP next hop is unreachable.
Refer to the exhibit. Which action would make the router the active VRRP router?
A. Recover interface Serial 1/0.
B. Increase priority in the configuration to 100.
C. Change the interface tracking priority to 100.
D. Recover interface Serial 1/1.
Refer to the Exhibit. The displayed QoS configuration has been configured on a router.
IPv6 is being implemented on the router, and it is required to convert the QoS policy to support both IPv4 and IPv6 on the same class.
Which alternative configuration would allow matching DSCP AF41 for both IPv4 and IPv6 on the same class map?
A. Class-map match-all CLASS1
Match dscp af41
B. Class-map match-all CLASS1
Match ip dscp af41
Match ipv6 dscp af41
C. Class-map match-any CLASS1
Match ip dscp af41
Match ipv6 dscp af41
D. Class-map match-any CLASS1
Match qos-group af41
Voice quality is bad due to high delay and jitter on a link. Which two actions will improve the quality of voice calls? (Choose two.)
A. Increase the queue size of the voice class.
B. Guarantee bandwidth during congestion to the voice class with a bandwidth command.
C. Increase the tx-ring of the egress interface.
D. Implement LLQ for the voice class.
E. Decrease the rx-ring of the egress interface.
F. Decrease the queue size of the voice class.
Refer to the exhibit. On what will the config class-map VOICE match?
A. only on UDP traffic between port ranges 16384 and 32767
B. only on DSCP EF traffic
C. on UDP traffic between port ranges 16384 and 32767, and on DSCP EF traffic
D. only on EF traffic that is UDP and within the UDP range of 16384 and 32767
A. R4 would receive an update noting R3’s higher cost to reach 172.30.1.0/24.
B. R4 would not receive any updates or queries, since R3 would simply move to the path through R2.
C. R4 would receive a query, since R3 would mark 172.30.1.0/24 as active when the link between R1 and R4 failed.
D. R4 would not receive any packets, since R3 is not using the link to R1 to reach 172.30.1.0/24.
Which three statements accurately describe a link-state routing protocol? (Choose three.)
A. Each router sends routing information to all nodes in the flooding domain.
B. Each router sends all or some portion of its routing table to neighboring routers.
C. Each router individually builds a picture of the entire flooding domain.
D. Each router has knowledge of all other routers in the flooding domain.
E. Each router is only aware of neighboring routers.
F. Each router installs routes directly from the routing updates into the routing table.
Refer to the exhibit. What is true about the configuration in this exhibit?
A. It is an invalid configuration because it includes both an application layer match and and a Layer 3 ACL.
B. It will create a class map that matches the content of ACL 101 and the HTTP protocol, and will then create an inspection policy that will drop packets at the class map.
C. It will create a class map that matches the content of ACL 101 and the HTTP protocol, and will then create an inspection policy that will allow packets at the class map.
D. It will create a class map that matches the content of ACL 101 or the HTTP protocol (depending on the zone of the interface), and will then create an inspection policy that will drop packets at the class map.
E. It will create a class map that matches the content of ACL 101 or the HTTP protocol (depending on the zone of the interface), and will then create an inspection policy that will allow packets at the class map.
F. It is an invalid configuration because the class map and policy map names must match.
Refer to the exhibit. Users that are connected to switch SWD are complaining about slow performance when they are doing large file transfers from a server connected to switch SWB. All switches are running PVST+. Which option will improve the performance of the file transfers?
A. Reconnect the clients from switch SWD to switch SWA.
B. Reconnect the clients from switch SWD to switch SWC.
C. Change PVST+ to RSTP.
D. Change the STP root switch from switch SWA to switch SWB.
E. Configure an EtherChannel between switch SWB and switch SWC.
Refer to the exhibit. Clients in VLAN 10 complain that they cannot access network resources and the Internet. When you try to ping the default gateway from one of the affected clients, you get ping timeouts. What is the most likely cause of this issue?
A. VLAN 10 is only enabled on trunk interfaces.
B. VLAN 10 is not created in the switch database.
C. STP is not running on the switch.
D. IP routing is disabled on the switch.
E. The switch CAM table is corrupted.
The Professional Cisco 350-001 Exam Free Dumps Help You 100% Pass Exam