QUESTION 271Study the exhibit carefully. Two directly connected routers are configured with OSPF. The output presented in the exhibit can be seen on the console of one router. What most likely cause this problem? A. The maximum transmission unit on either side of the link is not the sameB. This debug is wrong, OSPF does […]
350-001 certification dumps
QUESTION 261For the following protocols, which one provides a mechanism to transparently intercept and redirect CIFS traffic from a client to a local Cisco Wida Area Application engine? A. Virtual Router Redundancy Protocol (VRRP)B. File Transport Protocol (FTP)C. Hot Standby Routing Protocol (HSRP)D. Web Cache Communication Protocol (WCCP)
QUESTION 211When troubleshooting a network, the output of the command show interfaces indicates a large number of runts. What is a runt? A. the number of packets that are discarded because they exceed the maximum packet size of the mediumB. errors created when the CRC generated by the originating LAN station or far-end device does […]
QUESTION 201Refer to the exhibit. R7 (in Area 1) is redistributing routes that it learned from EIGRP into the OSPF process. R12 (in Area 4) receives a packet destined for a network in the EIGRP domain. What routing table entry will R12 have that will enable it to forward the packet?
QUESTION 171Which two of these steps are minimum requirements to configure OSPFv3 under IPv6? (Choose two.) A. Configure a routing process using the command ipv6 router ospf [process-id].B. Add the network statement for the interfaces on which OSPF will run.C. Configure OSPF on the interface that it will run on.D. Use the passive-interface command on […]
QUESTION 161What s the default stratum clock on a Cisco router, when you see the key word “master”configured on the NTP line? A. 1B. 2C. 4D. 6E. 8